Connecting Your Tank - Tera Gear 13 01 3007TG Assembly Instructions And Owner's Manual

Assembly
STEP 26
A. Remove the dust cap from the cylinder.
B. Place Propane Cylinder in the cabinet and fasten
in place with the Tank Securing Screw on the
Bottom Shelf Assembly (26).
C. Screw the regulator coupling nut on to the
tank valve clockwise or to the right, tightening by
hand only.
26
D. Perform leak test as found on page 32.
NOTE: This connection tightens clockwise and will not
allow gas to flow unless the connection is tight.
Only tighten by hand so the threads are not damaged.
WARNING: Do not use a wrench to tighten the
connection. Using a wrench could cause damage to the
regulator coupling or gas tank which could cause a leak.
Removing the tank –
To disconnect the LP gas cylinder
A. Turn the bruner knobs to the off position
B. Turn the cylinder valve off fully.
C. Detach the regulator assembly from the cylinder
valve by turning the regulator coupling nut counter
clockwise.
STEP 27
Complete
31
TG3007 LP U&C-2012 FA.indd 31 12-09-26 4:06 PM