Table of Contents
Advertisement
3.8
BURNER SURROUND INSTALLATION
You can choose to install a platform with crushed glass or imitation logs around the burner.
WARNING:
It is mandatory to install either the platform or imitation logs around the burner to maintain the appropriate
volume of the combustion chamber. Do not leave the space around the burner empty.
3.8.1
IMITATION LOG INSTALLATION
Four log pieces are required to completely surround the burner (each one surrounds a corner of the burner).
If you have a recessed fireplace, two pieces will be enough (they will be installed in front of the burner.) If you use
four log pieces, start at the back. The large log goes on the left back corner and the small one lines up on the
right back corner of burner. Then install the other large log in front of the burner; on the longer side, there is a
clearance space to surround the pilot. The large log goes on the front right corner of the burner. Finish installation
by inserting the small log on the front left corner of burner, lining it up with the large log (figures 3.8.a and 3.8.b).
Finally, spread 3 cups of glass around the logs.
3.8.2
PLATFORM INSTALLATION
The platform is designed to be adapted to any configuration of the gas fireplace. Remove the glass door (see
8.3.1) and install the platform as shown in the following images. Then, spread 3 cups of ember glass evenly on
the platform.
Figure 3.8.a
Figure 3.8.b
43
Advertisement
Table of Contents
