Table of Contents
Advertisement
3.3
INSULATING SLEEVE INSTALLATION
All our gas fireplace models come with an 8 ft. insulating sleeve. It must be installed when assembling the vent
with the fireplace. Before putting the vent in place and fastening it, slide the sleeve around it, leaving only a few
inches of the vent exposed. Fasten the vent to the fireplace and slide the sleeve back down so that it completely
covers the base of the pipe. Using heat-resistant tape (aluminum), secure the sleeve to the fireplace.
WARNING:
Whatever the model of home and vent configuration, the insulation sheath must always be installed.
Figure 3.3.a
If the sleeve needs to be held upright, fasten the end of the sleeve with three self-drilling screws. Screw in the
vent. .
3.4
FAN INSTALLATION
Fans are used to circulate the heat from the fireplace in the room. They are sold by two at your retailer's
(optional). Fans are installed in the lower part of the fireplace. They must be fixed to the fasteners located at the
bottom of the fireplace using screws and oriented toward the recessed sides of the fireplace. To do this, remove
®
SmartCase
the
(see 5.1) and place the fans as well as the thermo-disc (7.4).
Figure 3.3.b
Figure 3.3.c
40
Advertisement
Table of Contents
