Table of Contents
Advertisement
• Have the exhaust system and the fireplace inspected by a qualified technician every year before the heating
season begins
. • Use a gentle cleaner on the windows. Do not use abrasive products; abrasive products damage glass will
damage the surface of the glass.
THE INSTALLER MUST READ THIS MANUAL CAREFULLY BEFORE INSTALLING OR
USING THIS APPLIANCE. PLEASE REFER TO LOCAL CODES, WHERE APPLICABLE.
J. A. ROBY assumes no liability and makes no warranties if some of this eventuality became.
•
A bad installation.
•
Used with a damaged component.
•
A vent system installation that does not met J. A. ROBY's instructions;
•
The crushed glass was not placed properly on the burner
•
Used of any component not approved by J. A. ROBY.
WARNING:
It is important to handle all appliance components (doors, SmartCase
1.3
GENERAL SAFETY INFORMATION
1.3.1
CARBON MONOXIDE
• An installation that does not comply with the recommendations described in this manual can lead to carbon
monoxide emissions. As a safety measure, we strongly recommend for a carbon monoxide detector to be
installed near the unit.
Signs of a carbon monoxide poisoning (headaches, dizziness and nausea) are similar to those of
influenza. If you have these symptoms, your fireplace may not have been installed correctly. Turn off
the gas fireplace and go outside immediately for some fresh air! Have the fireplace inspected by a
qualified technician.
1.3.2
GAS ODOR
• Propane gas/LPG and natural gas are odorless. An odorant (usually sulfur) is added to each one of these gases
which makes them smell similar to rotten eggs. This will help you easily detect any eventual leak. However, the
odor added to these gases can fade. Gas may be leaking without releasing any smell. We therefore strongly
recommend that a gas detector be installed near the unit.
®
, burner, etc.) with care during maintenance.
13
Advertisement
Table of Contents
