Monitoring The Spa932; Configuring The Web Service; Web Interface Basic And Advanced Views; Configuration Parameters - Linksys SPA 900 Series Administration Manual

Configuring the Web Service

For instructions about how to configure phone extensions using the SPA Installation Wizard or the
administration web server, refer to the SPA9000 Administration Guide.
Repeat Step 9 for each extension or user that you are monitoring using the SPA932.
Step 13
Click Submit All Changes at the bottom of the page.
Step 14

Monitoring the SPA932

To display the status of the SPA932, click the SPA932 Status link on the SPA932 tab. The sys-
tem displays the screen shown in
Figure 3-7
For information about each field on this display, refer
Configuring the Web Service
Note Only web-enabled phones allow these features.

Web Interface Basic and Advanced Views

You can access configuration parameters using either the Basic or Advanced view. The SPA
Provisioning tab is only visible from the Advanced Administrator view of the web interface.
Switching between the Basic and Advanced views discards the uncommitted changes that have been
Warning
made on the web pages.

Configuration Parameters

You can configure SPA phone parameters in two ways:
Linksys IP Phone Administrator Guide
3-14
Figure
SPA932 Status
Chapter 3
3-7.
toChapter 5, "Linksys IP Phone Field
Managing Linksys IP Phones
Reference".
Firmware Version 5.1