Bulb Replacement - Volvo XC 90 Owner's Manual

Related information
•
Volvo service programme (p. 474)
11 An authorised Volvo workshop is recommended.
LED (Light Emitting Diode)
12

Bulb replacement

The bulbs in halogen headlamps can be
replaced by the driver.
The bulbs in the halogen headlamp can be
replaced without the help of a workshop, but the
plastic cover over the headlamp must be removed
before the bulbs can be replaced.
Lift off the rubber strip by pressing it inward
in the engine compartment.
MAINTENANCE AND SERVICE
Release the pins in the plastic cover's four
clips by pressing down the pins with a screw-
driver or similar and removing the cover.
Refit the cover in reverse order.
NOTE
The pins in the clips need to be pressed back
completely before the clips are refitted in the
cover.
When the cover is refitted the pins must be
pressed in until their end surfaces are level
with the surfaces of the clips.
The dipped beam bulb becomes accessible when
the headlamp's round rubber cover is removed.
Bulbs for the direction indicator, main beam and
the daytime running light/position lamp become
accessible when the headlamp's oval cover is
removed.
11
Contact a workshop if faults occur in other
lamps. This also applies to the bulbs for reversing
lights. If a fault occurs in LED 12 lamps, the entire
lamp unit usually must be replaced.
}}
489