Volvo XC 90 Owner's Manual page 223

WARNING
For safety reasons, the third seat row
be lowered when the safety grille is fitted in
the car.
Installation
1. Lower the rear seat and then lift the safety
grille in through one of the rear side doors or
via the tailgate - the arched/convex side of
the grille should face the cargo area while
the hooks on each side point up. The attach-
ing braces and plastic sleeves are not used
in this stage.
2. Guide one of the safety grille's hooks into
the larger opening in the roof mounting (1).
Grasp the grille near the hook and pull/slide
it towards the smaller opening (2).
> The hook is now secured in the roof
mounting's end position.
Applies to 7-seat cars.
3
3. Repeat the steps in point 2 above to secure
the other hook in the mounting on the other
3
must
side.
WARNING
Make sure the hooks of the safety grille are
securely fitted in the roof mountings so there
is no risk of the grille coming loose.
4. Hook the attaching brace's hook through the
load securing eyelet at the cargo floor from
underneath, and guide the threaded part
through the cargo grille's lower attachment
hole from underneath (1).
Slide a plastic sleeve on the threaded part of
the attaching brace - the sleeve flange
should face up - and guide it down through
the hole. Then screw on the screw cap until
its lower edge is approx. 5 mm from the grille
(2).
LOADING AND STORAGE
5. Repeat the steps in point 4 on the other
side.
6. Centre the safety grille and then tighten the
two attaching braces alternately until the
grille is properly secured.
Removal
To remove the safety grille - proceed in reverse
order from the installation instructions above.
Note that the attaching braces can be removed
before the plastic sleeves are removed from the
holes in the grille.
Related information
•
Loading (p. 213)
•
Load retaining eyelets (p. 215)
•
Safety net (p. 218)
•
Cargo cover (p. 216)
221