Volvo XC 90 Owner's Manual page 165

6. Locate programming button
18
receiver for the garage door or similar. It is
normally located near the antenna bracket on
the receiver.
7. Depress and release the receiver's program-
ming button. Step 8 must be completed
within 30 seconds of the button being
depressed.
8. Depress the button being programmed, hold
it depressed for 2 seconds and then
release it. Repeat the sequence of press-
ing/holding/releasing a second time and,
depending on the receiver model, even a
third time. Programming is now be com-
plete and the garage door, gate or similar
should now be activated when the pro-
grammed button is depressed.
Button designation and colour vary depending on manufacturer.
18
Operation
When HomeLink
used in place of the separate original remote
controls.
Depress the programmed button. The garage
door, gate, alarm system or similar is activated
(may take a few seconds). The indicator lamp illu-
minates or flashes when the button has been
depressed. Naturally the original remote controls
can still be used in parallel with HomeLink
on the
required.
NOTE
If the ignition is switched off, HomeLink
work for 30 minutes after the driver's door
has been opened.
In the event of programming problems, contact
®
HomeLink at www.HomeLink.com,
www.youtube.com/HomeLinkGentex or call the
toll-free number 00 8000 466 354 65 (or the
toll number +49 6838 907 277).
Resetting the HomeLink
It is only possible to reset all of the HomeLink
buttons at the same time, not each button indi-
vidually. However, individual buttons can be
reprogrammed; see the section "Programming
individual buttons" below.
®
is fully programmed it can be
®
if
®
will
®
buttons
®
INSTRUMENTS AND CONTROLS
1. Depress buttons 1 and 3 on HomeLink
hold them depressed until the indicator lamp
begins flashing green (about 10 seconds).
2. Release the buttons.
®
> HomeLink
is now set to "learn mode"
and is ready to be reprogrammed; see the
section "Programming HomeLink
above.
Programming individual buttons
To reprogram an individual HomeLink
proceed as follows:
1. Depress the required button and do not
release.
2. After approx. 20 seconds when the indicator
®
lamp on HomeLink starts to flash yellow,
start with step 1 from the section "Program-
®
ming HomeLink " above.
Note: If the button to be reprogrammed is
not programmed with a new unit, it will
resume the previously saved programming.
For more information or to provide feedback
®
about HomeLink , visit www.HomeLink.com,
www.youtube.com/HomeLinkGentex or call the
toll-free number 00 8000 466 354 65 (or the
toll number +49 6838 907 277).
Related information
•
®
* (p. 161)
HomeLink
* Option/accessory, for more information, see Introduction.
®
and
®
"
®
button,
163