Using The Emergency Puncture Repair Kit - Volvo XC 90 Owner's Manual

Using the emergency puncture
repair kit
Seal a puncture with the emergency puncture
repair kit, Temporary Mobility Kit (TMK).
Overview
Cable
Air hose
Pressure reducing valve
Protective cap
Bottle holder (orange-coloured cap)
Pressure gauge
Label, maximum permitted speed
Sealing fluid bottle
Switch
Connecting
1. Set up the warning triangle and activate the
hazard warning lights if a tyre is being sealed
in a trafficked location.
If the puncture was caused by a nail or simi-
lar, allow this to remain in the tyre. It helps to
seal the hole.
2. Detach the label for maximum permitted
speed (which is fitted on one side of the
compressor) and affix it to the steering
wheel. You should not drive faster than
80 km/h after the emergency tyre repair kit
has been used.
WHEELS AND TYRES
3. Check that the switch is in position 0 and
locate the cable and the air hose.
NOTE
Do not break the bottle's seal before use. The
seal is broken automatically when the bottle is
screwed in.
WARNING
The sealing fluid can irritate the skin. In the
case of contact with skin, wash away the fluid
with soap and water.
4. Unscrew the orange cap and unscrew the
bottle's stopper.
5. Screw the bottle into its holder. Do not then
unscrew the bottle again, it is equipped with
a reverse catch to prevent leakage.
6. Unscrew the wheel's dust cap and screw in
the air hose valve connection to the bottom
of the thread on the tyre's air valve.
}}
461