Volvo XC 90 Owner's Manual page 141

10
Car with LED headlamps*
Unlike what happens during conventional dim-
ming, the light beam continues with main beam
on both sides of oncoming traffic or vehicles
ahead - only the part of the light beam that
points directly to the vehicle is dimmed.
Dipped beam directly towards oncoming vehicle, but
continued main beam on both sides of the vehicle.
The lighting returns to full main beam about a
second after the camera sensor no longer
detects the headlamp beams from oncoming
traffic or the rear lights from vehicles in front.
Activate/deactivate
The function can start while driving in the dark
when the car's speed is 20 km/h or higher.
Activate/deactivate active main beam by moving
the steering wheel stalk switch's rotating ring to
LED (Light Emitting Diode)
10
position and release. If active main beam is
deactivated while main beam is on, the lighting is
immediately reset to dipped beam.
When active main beam is activated, the symbol
illuminates with a white glow in the driver
display.
When main beam is activated, the symbol shines
blue. This also applies for LED headlamps if the
main beam is partially dimmed, i.e. as soon as the
light beam shines with slightly more than dipped
beam.
INSTRUMENTS AND CONTROLS
Manual operation
NOTE
Keep the windscreen surface in front of the
camera sensor free from ice, snow, mist and
dirt.
Do not stick or attach anything to the wind-
screen in front of the camera sensor as this
may reduce effectiveness or cause one or
more of the systems dependent on the cam-
era to stop working.
If this symbol is shown in the driver dis-
play, together with the message
High Beam Temporarily
unavailable , then switching between
main and dipped beam must be performed man-
ually. The rotating ring on the stalk switch can still
be in the position. The
guishes when these message are shown.
The same applies if this symbol is
shown together with the message
Windscreen sensor Sensor
blocked, see Owner's manual
Active main beam may be temporarily unavailable
e.g. in situations with dense fog or heavy rain.
When active main beam becomes available again,
or the windscreen sensors are no longer blocked,
* Option/accessory, for more information, see Introduction.
Active
symbol extin-
.
}}
139