True CS900 Owner's Manual page 19

CHAPTER 2: ASSEMBLY INSTRUCTIONS
BIKE ASSEMBLY STEPS (continued):
Step 9: Console Mounting:
a) The screws used to attach the Console are
provided in the Console packaging
b) Align the back of the Console with the Front
Mast Console Mounting Plate
c) Attach the Console to the Mounting Plate by
tightening all 4 screw with a Phillips head
screwdriver (not provided)
Hardware Required:
*Included with console
Step 10: Cable Connections :
a) Remove Electronics Board ground wire
screw
b) Re-attach both the Electronics Board ground
wire and the Console ground wire to the Front
Mast Mounting Plate using the same ground
screw.
c) Handlebar Cable Connections:
• Telemetry HR (3-pin connector)
Right Thumb Switch (6-pin connector)
•
• CHR_(L) & CHR_(R) (3-pin connectors)
It is acceptable to install either cable connector
into either Electronics Board CHR location.
d) Front Mast Cable Connection:
• 20-pin Connector
CHR L & R
Telemetry HR
Truefitness.com / 800.426.6570 / 636.272.7100
Right Thumb Switch
20-Pin Connector
15