True CS900 Owner's Manual page 15

CHAPTER 2: ASSEMBLY INSTRUCTIONS
BIKE ASSEMBLY STEPS (continued):
Step 2: Front Stabilizer Bar (continued):
b) For each screw, install through split washer
then flat washer
c) Insert Front Stabilizer into the metal bracket
Install each screw through the bottom of the
metal bracket, then through the Front Stabilizer
d) Tighten using the provided hex wrench
Hardware Required:
2 M8 x 70 Screws
2 M8 Washers 2 M8 Spring Washers
Step 3: Seat Saddle:
a) Remove the flat washers and nuts from the 3
threaded rods on the bottom of the Seat Saddle
b) Insert Seat Saddle onto the Seat Post
Mounting Plate; the threaded rods on the
bottom of the Seat Saddle will align with the 3
openings on the Seat Post Mounting Plate
c) For each threaded rod, install flat washer
followed by nut
d) Tighten using the provided wrench
Hardware Required:
*Included with seat saddle
Preparation for Step 4:
a) Install the Mast Boot component (including
rubber gasket) onto the Front Mast tube
b) Verify that the Mast Boot is installed in the
correct orientation as shown.
Truefitness.com / 800.426.6570 / 636.272.7100 11