True CS900 Owner's Manual page 17

CHAPTER 2: ASSEMBLY INSTRUCTIONS
BIKE ASSEMBLY STEPS (continued):
Step 4: Front Mast Cable Routing:
*Complete the power supply installation on page 23 prior to completing this step if this unit will be paired with a
touchscreen or 15" TFT console.
a) Pull the cable bundle coming from the base
of the unit through the front mast using the
pull tie provided with the mast.
NOTE: This connector is only used for the
touchscreen or 15" TFT console installation.
If installing a touchscreen or 15" TFT
console, please refer to "Power Supply
Installation, Step A" before proceeding with
"Front Mast Cable Routing, Step # 4".
Step 5: Front Mast:
a) For each screw, install through split washer
then flat washer
b) Insert the Front Mast onto exposed bike
frame U-bracket; pay special attention not to
pinch any wires between the Front Mast and
the frame
c) Verify that the Front Mast is in the correct
orientation
d) Secure the Front Mast to the bike frame by
tightening all 6 screws with the provided hex
wrench
e)Verify that the Front Mast is secured tightly
to the bike frame; tighten screws if necessary
Hardware Required:
6 M8 x 20 Screws
6 M8 Washers 6 M8 Spring Washers
Truefitness.com / 800.426.6570 / 636.272.7100
Pull Tie
13