Removing The Drawer Assembly - Jenn-Air JMD2124WS Technical Education

REMOVING THE DRAWER ASSEMBLY

1. Open drawer and extend it fully.
2. Locate the drawer support cover on the
back of the frame on both sides of the
Drawer Assembly.
3. Using a putty knife gently pry on the side
of the cover until it snaps out,
see figure 1.
Drawer Front
Putty Knife
Drawer Support Angle
Figure 1
4. Remove two screws on either side of the
drawer support angles securing the drawer,
see figure 2.
Tabs
Figure 2
Screw Locations
4-8
Drawer Bottom
Screws
Figure 3
5. Once all screws are removed, release
the side support angles by pulling the
angles out slightly to clear the tabs.
Lift and remove the drawer assembly
see figure 2.
Figure 4
6. With the Drawer removed,
the oven cavity can easily be serviced.
see figure 4.
Center Drawer Support
(Rack Gear)