Installation Requirements - Jenn-Air JMD2124WS Technical Education

INSTALLATION REQUIREMENTS

Tools and Parts
Tools Needed
Gather the required tools and part s before starting installation.
Read and follow the instructio ns provided with any tools
listed here.
Measuring tape
Pencil
No. 2 Phillips screwdriver
Parts Supplied
The microwave drawer is preassembled.
1" (2.5 cm) mounting screws (4)
Materials needed
6" (15.2 cm) Anti-Tip bloc k (installer to provide)
Minimum Installation Clearances
For proper installation, the following minimum clearances must exist above and below the cutout opening.
A
2" (5.1 cm)
2" (5.1 cm)
WARNING
WARNING
WARNING
Excessive Weight Hazard Excessive Weight Hazard
Use two or more people to move
Use two or more people to move and
install the microwave oven.
and install the microwave oven.
Failure to do so can result in back or
Failure to do so can result in back or
other injury. other injury.
INSTALLATION REQUIREMENTS
Drill
1/16" (2 mm) drill bit
Minimum Dimensions
B
19"
(48.3 cm)
A. Upper oven
B. Lower cabinet
C. Counter
Location Requirements
The microwave drawer may be located in a cabinet or below the
counter, and/or below a built-in oven. Check the opening where
the microwave drawer will be inst alled. The location must provide:
Wood cabinetry.
Cutout opening that is plu mb and square. See "Minimum
Cutout Dimensions" in "Minimum Dimensions" section.
Cutout floor that is solid, level and flush with bottom of
cabinet cutout.
Support for weight of at least 100 lbs (45.4 kg), which includes
microwave oven and items placed inside.
Grounded electrical outlet. See "Electrical Requirements"
section.
Minimum installation clearances for installation location. See
"Minimum Dimensions" section.
Complete enclosure around the recessed portion of the
microwave drawer.
C
2" (5.1 cm)
2" (5.1 cm)
2-1
B
36"
(91.4 cm)
19"
(48.3 cm)