WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug microwave drawer or disconnect
power.
2.
Discharge the high voltage
capacitor terminals with a 20,000 W
2 watt resistor to chassis ground.
3.
Follow the "Removing the Drawer
Assembly on page 4-8.
4.
Pull the center slide rail (rack gear)
as far as it will go, see figure 1.
Center Slide Rail
Figure 1
REMOVING THE RACK GEAR
Rack Gear
Top side of center slide rail
5.
Disengage the clip on the slide rail,
see figure 2 and 2A.
6.
Pull slide rail straight out to remove.
7.
Remove the (3) screws holding the
rack gear to the bottom slide rail,
see figure 3.
Bottom side of center slide rail
4-19
Clip
Figure 2
Figure 2A
Three Screws
Figure 3