Removing The Auto Drawer Gear - Jenn-Air JMD2124WS Technical Education

REMOVING THE AUTO DRAWER GEAR

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug microwave drawer or disconnect
power.
2. Remove the microwave drawer from the
cabinet as outlined in steps 1-4 of
Accessing Internal Components (see
page 4-2 for the procedure).
3. Remove the top and right side panels as
outlined in the steps Accessing Internal
Components (see page 4-2 and 4-3 for
the procedure).
4. Discharge the high voltage
capacitor terminals with a 20,000 W
2 watt resistor to chassis ground.
Clearance Hole in
Bottom Cover for
Screwdriver
Figure 1a
5. Open the drawer and keep it open.
6. Unhook wiring to Auto Drawer Gear.
7. Remove bottom screw below Auto
Drawer Gear, see figure 1a and 1b.
8.
Four Screws
9.
10. Tilt Auto Gear Motor 20° to remove
Slide to Back
Bottom Cover
4-18
Base Plate
Figure 1b
Remove the (4) screws holding the auto
drawer gear to the bottom cavity angle,
see figure 2.
Figure 2
Disengage (pull) Auto Drawer Gear
from rack gear and slide to the right
(toward the rear), then turn motor 90° and
slip out along rear of drawer, see figure 3.
the assembly.
Figure 3
Tilt 20°
Figure 4
Screwdriver
Bottom Cover
Turn 90°