Removing The Humidity Sensor - Jenn-Air JMD2124WS Technical Education

REMOVING THE HUMIDITY SENSOR

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug microwave drawer or disconnect
power.
2. Remove the microwave drawer from the
cabinet. (see page 4-2 for the
procedure).
3. Remove the top panel. (see page 4-2
figure 2.)
Humidity Sensor
Stirrer Motor
Figure 1
(left rear with the top panel removed)
4.
5.
Two Screws
4-11
Remove two screws securing the
humidity sensor to the microwave top,
see figure 1.
Disconnect the connector with the
shielded black red and white wires from
the control PCB at location CNF,
see figure 2.
CNF
Figure 2
Black Red and
White Shielded
Wires