Advertisement
Bottom Duct Assembly
1. Attach bottom duct to duct base.
A
B
A. Duct base
B. Bottom duct
2. Remove 4 existing screws (2 on each side) from the
microwave oven. The screws are located at the lower edge.
These screws will be used in the next step.
3. Secure duct base to the microwave oven with the 4 existing
screws removed in Step 2.
A
B
A. Duct base
B. Existing screws (4)
4. Attach rear duct bracket to duct base, and secure with one
9/16" screw.
NOTE: If there are louvers on the top of the convection cover,
block the louvers with the provided aluminum tape. Remove the
screw from under the air guide and remove air guide. See inset.
A
B
C
A. Duct base
B. Rear duct bracket
C. 9/16" screw
5. Remove 1 existing screw from upper right corner of the back
of the microwave oven, and set aside for use in the next step.
D
E
F
D. Aluminum tape
E. Air guide
F. Air guide screw
6. Place rear duct on back of microwave oven, as shown, and
secure with existing screw removed in Step 5.
A
B
A. Existing screw
B. Rear duct
7. Attach upper duct to back of microwave oven, as shown, with
one 9/16" screw.
A
B
A. 9/16" screw
B. Upper duct
Microwave Oven Installation
1. On the cutout floor, find and mark the centerline.
2. Use Template 1 to mark hole center for 3/16" screw. Be sure
to align the center line of template to center line of cutout floor.
A. Cutout floor
B. Center line
C. Cutout opening
3. Using 7/64" drill, drill pilot hole into hole center marked in Step 2.
"
(37.5 cm)
A
B
C
3
Advertisement
