Jenn-Air JMD2124WS Technical Education page 28

REMOVING THE SECONDARY INTERLOCK SWITCH, MONITOR
SWITCH AND FRONT AND REAR DOOR SWITCH (continued)
Connectors
Figure 5
8. The rear door switch is located behind
the side panel on the left side of the
microwave, see figure 4.
9. Remove the connectors and one
screw to relpace, see figure 5.
Figure 6
NOTE: This switch is mounted on the right
side of the microwave. The switch is
accessed in a similar manner as the left side
as described in removal steps on pages 4-4
and 4-5.
Rear Door Switch
Screw
Door Sensing Switch
Re-install
1. Re-install each switch in its place. The
secondary interlock switch is in the
lower position and the monitor switch is
in the top position, located on the left
side of the unit, see figure 3.
The door sensing switch by itself on the
right side of the unit, see figure 4.
2. Re-connect wire leads to each switch.
Refer to pictorial diagram.
NOTE: Reinstall the switch assembly bracket
and then connect the wires to the switch ter-
minals. Use the correct diagram to make sure
of your connections.
3. Secure the latch hooks with mounting
screws to oven flange.
4. Make sure that the monitor switch is
operating properly and check continuity
of the monitor circuit.
4-6