Transmitter Programming; Programme Mode Features - Eaglemaster E4 User Manual

Transmitter programming:

This programming features is provide the owner to learn the new transmitter into the system memory. This
system can expand 4 different transmitters, and comes from factory with two transmitters already
programmed into the system memory (1-way & 2-way ) . Whenever you want to add or delete transmitter
code , the procedures are as following:
1. Enter Valet mode, the LED on status.
2. Turning ignition switch from ON to OFF and within 10 seconds, press Valet switch on-off
for 5 times, siren will provide 3 long chirp.
3. Now you have insert your former (old)PIN code to release this programming mode.
For example your old PIN code is "2.5", turn ignition ON , LED start flashing (the times
of LED flashing is according to the 1st PIN code), While LED flashing 2 times then turn
ignition OFF, thus the 1st PIN code entered. Turn ignition ON again, LED start flashing,
while it flashing 5 times then turn ignition OFF, thus the 2nd PIN code entered.
If the 2-digits PIN code entered correctly, the siren will provide 1 long chirp and the LED
will flashing fast to indicate that the system is in Learning mode.
Note: If enter not correct PIN code, siren will give 2 short chirps and exit this
mode and back to Valet mode. Please repeat procedure step # 4 again.
4. Follow from 1-long chirp, LED flashing fast, It's available to learn the new transmitter into the
system by press any button once of the new transmitter, siren will give 1-long and 1-short chirps
to indicate the first transmitter code learn into the system memory.
To learn the 2nd,3rd,4th new transmitters, simply press any button once on the each transmitter,
the numbers of siren short chirps is according to the numbers of the new transmitters learn into
the system memory . (Each time learning new code of remote, the old code will be erased, hence
you have to learn again.)
5. To exit this programming mode, if there is no new transmitters button been pressed, turn ignition
to ON or within 20 seconds without any button pressed , siren will give 2 short chirps and back
to the Valet mode.

Programme mode features:

Many of the operating settings of this unit are programmable. The programmable mode setting
dictates how the unit operates.
To enter programme mode and access Feature Change:
1. Disarmed the system, turn ignition from ON to OFF, within 10 seconds press valet Switch ON-OFF
for 5 times.
2. Siren will 2 long and 2 short chirps. Then turn the ignition switch to ON, and LED will steady ON to
confirm the system is in programme mode.
3. Press the Valet switch, the times of Valet switch press is according to the number of function, and
each time the Valet switch is pressing the siren will activated for identification.
The status LED flash times to indicate a certain function number.
4. -To press the
transmitter. You will hear 1, 2, 3, 4 siren chirps depending on the new status of the function.
-To press the
chirp to confirm the feature status.
5. Exit by: turning Ignition to OFF , the system will exit the programming mode and siren will give two
short chirps .
button : Change the status of the function by press the button
button : Confirm the feature status, press the
of the
button, siren will give short