Antenna Call Switch; Set Your Own Pin Code - Eaglemaster E4 User Manual

R.F Antenna CALL SWITCH :
Call switch

Set your own PIN code :

The system provide 2 digit PIN code and it can be programme your own PIN code.
Whenever you set your own PIN code of the system, the procedures are as following:
1.
Enter Valet mode, the LED on status.
2.
Turning ignition switch ON to OFF for 8 times within 10sec. , and steady in OFF
position, siren will provide 1 long chirp.
(Each time ignition switch turned off, siren will give 2 chirps for indication)
3.
Now you have insert your former (old)PIN code to release this programming
mode. For example your old PIN code is "2.5", turn ignition ON , LED start
flashing (the times of LED flashing is according to the 1st PIN code), While LED
flashing 2 times then turn ignition OFF, thus the 1st PIN code entered.
Turn ignition ON again, LED start flashing, while it flashing 5 times then turn
ignition OFF, thus the 2nd PIN code entered.
If the 2-digits PIN code entered correctly, the siren will provide 2 long chirp and
LED off . System now is in the new PIN code programming mode.
Note: If enter not correct PIN code, siren will give 2 short chirps and exit this
mode and back to Valet mode. Please repeat procedure step # 4 again.
4.
Follow from 2-long chirp, the system under new PIN code setting mode.
Suppose to set new PIN code : ( 3 . 8)., Turn ignition to ON , at time the LED will
start flashing (the times of LED flashing is according to the 1st PIN code), While
LED flashing 3 times then turn ignition OFF, thus the 1st PIN code been
programmed.
Turn ignition to ON again, LED start flashing, while it flashing 8 times then turn
ignition OFF, thus the 2nd PIN code been programmed.
5.
At the time system of Led will indicating to identify the New Pin code.3.8 (3 flash
Pulse then 8 flash). Siren will give 2 short chirps to identify the new PIN has been
programmed.
6.
Then system existed new pin code setting and return back to the Valet mode.
The R.F antenna module provide a switch which can be
send a signal to the 2-way remote.
In disarmed or ACC on position, if press Call switch for
2 seconds, lights will flashing 5 times and the 2-way
remote will give pre-warn beep sound . The vehicle
page mode icon displays when the alarm module is
paging the transceiver.
2-way LCD display :
+ pre-warn sound