Advanced Screen; Add Bandwidth Management Rule - ZyXEL Communications LTE3301 Series User Manual

17.5 Advanced Screen

Use this screen to configure bandwidth management rules for the pre-defined services or
applications.
You can also use this screen to configure bandwidth management rule for other services or
applications that are not on the pre-defined list of LTE3301. Additionally, you can define the IP
addresses and port for a service or application.
Click Management > Bandwidth MGMT > Advanced to open the bandwidth management
Advanced screen.
Figure 76 Management > Bandwidth Management > Advanced
The following table describes the labels in this screen.
Table 52 Management > Bandwidth Management > Advanced
LABEL
Add New Rule
#
Status
Grouping
Service
Control
Direction
Modify
Restart
Reset QoS Rule

17.5.1 Add Bandwidth management Rule

If you want to create a new bandwidth management rule for a service or application, click the Add
New Rule icon in the Advanced screen. The following screen displays.
Chapter 17 Bandwidth Management
DESCRIPTION
Click this to open a screen where you can create a new bandwidth management rule for a
service or application.
This is the number of an individual bandwidth management rule.
This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
This field displays the IP address or a range of IP addresses of the destination computer
for whom this rule applies.
This field displays the protocol and port used for the service.
This field displays whether the maximum/minimum bandwidth allowed or a priority level
is specified in the rule.
These read-only labels represent the physical interfaces. Bandwidth management applies
to all traffic flowing out of the router through the interface, regardless of the traffic's
source.
Click the remove icon to delete the rule.
Click this button to begin configuring this screen afresh.
Click this button to remove all bandwidth management rules.
LTE3301 Series User's Guide
116