ZyXEL Communications LTE3301 Series User Manual page 132

Click Maintenance > Backup/Restore. Information related to factory defaults, backup
configuration, and restoring configuration appears as shown next.
Figure 95 Maintenance > Backup/Restore
The following table describes the labels in this screen.
Table 61 Maintenance > Backup/Restore
LABEL DESCRIPTION
Backup Click Backup to save the LTE3301's current configuration to your computer.
File Path Type in the location of the file you want to upload in this field or click Browse... to find it.
Browse... Click Browse... to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Upload Click Upload to begin the upload process.
Note: Do not turn off the LTE3301 while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the LTE3301 again. The LTE3301 automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Reset Pressing the Reset button in this section clears all user-entered configuration information
and returns the LTE3301 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
LTE3301. Refer to the chapter about introducing the Web Configurator for more information
on the RESET button.
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default LTE3301
IP address (192.168.1.1). See
your computer's IP address.
Chapter 20 Maintenance
Appendix B on page 148
LTE3301 Series User's Guide
132
for details on how to set up