Advanced Screen - ZyXEL Communications VMG1312-T10C User Manual

6.9 Advanced Screen

Use this screen to configure advanced wireless settings. Click Network Setting > Wireless >
Advanced, the screen appears as shown.
See Section 6.10.1 on page 74
Figure 40 Network Setting > Wireless> Advanced
The following table describes the labels in this screen.
Table 22 Network Setting > Wireless> Advanced
LABEL
Fragmentation
Threshold
Output Power
Preamble
802.11 Mode
VMG1312-T10C User's Guide
for detailed definitions of the terms listed in this screen.
DESCRIPTION
This is the maximum data fragment size that can be sent. Enter a value between 256 and
2346.
Set the output power of the Device. If there is a high density of APs in an area, decrease
the output power to reduce interference with other APs. Select one of the following:
100%, 75%, 50% or 25%.
Select a preamble type from the drop-down list menu. Choices are Long or Short.
Select 802.11b to allow only IEEE 802.11b compliant WLAN devices to associate with the
Device.
Select 802.11g to allow only IEEE 802.11g compliant WLAN devices to associate with the
Device.
Select 802.11b+g to allow either IEEE 802.11b or IEEE 802.11g compliant WLAN
devices to associate with the Device. The transmission rate of your Device might be
reduced.
Select 802.11n to allow only IEEE 802.11n compliant WLAN devices to associate with the
Device.
Select 802.11g+n to allow either IEEE 802.11g or IEEE 802.11n compliant WLAN
devices to associate with the Device. The transmission rate of the Device might be
reduced when an 802.11g wireless client is associated with it.
Select 802.11b+g+n to allow IEEE 802.11b, IEEE 802.11g or IEEE 802.11n compliant
WLAN devices to associate with the Device. The transmission rate of the Device might be
reduced when an 802.11b or 802.11g wireless client is associated with it.
Note: The transmission rate varies depending on the mode the wireless client uses to
associate with the Device.
Chapter 6 Wireless
73