Huviron SK-V207IR-Z946 User Manual page 32

4.2.5.1 TIME SCHEDULE SETTING
1) Number : Select number of schedule. Up to 8 timeline can be selected for a day.
Default value is 1.
2) Enable : Determine whether to use this function or not.
3) Master Enable :
ㆍCurrent :
ㆍAll off : It changes set point of Enable from No.1 to No.8 to OFF
ㆍAll on : It changes set point of Enable from No.1 to No.8 to ON
4) Start Time :
then press again the IRIS OPEN or MENU key to select minute. After that you should
press the 'IRIS CLOSE' key to escape this menu.
5) End Time :
6) Time Act : Select the sequencing action to schedule the action.
ㆍOFF : No action.
ㆍPTRN 1~4 :
ㆍSEQ 1~8 :
ㆍCW : Scan clockwise automatically.
ㆍCCW : Scan counterclockwise automatically.
ㆍCustom :
7) Set :
Save the value and then move out this menu.
: When turning ON this menu, the timetable appears as shown on the picture.
Chapter 4. Menu configuration and operating
It manages Schedule Enable from No.1 to No.8.
It changes set point of Enable at the point of enterring menu.
Set start time. Press the IRIS OPEN or MENU key to select hour and
Set end time.
The camera move as PTRN1~PTRN4.
The camera move as SEQ1~SEQ8.
The camera working Auto Scan mode by custom mode.
TIME TABLE --------------------------------
No Ena Act
1. On PTRN1
2. Off SEQ1
3. Off CCW
4. Off CW
5. Off SEQ2
6. Off SEQ3
7. Off PTRN
8. Off PTRN
Press Menu To Exit
[Menu 4-15] Time Table Menu
Start End
13:30 14:55
~
00:00 00:00
~
00:00 00:00
~
00:00 00:00
~
00:00 ~ 00:00
00:00 00:00
~
00:00 00:00
2
~
3
00:00 ~ 00:00
32