Huviron SK-V207IR-Z946 User Manual page 22

Not only basic function such as Pan/Tilt/Zoom but additional functions are available for this
camera. Additional functions are as follow.
1. PRESET
2. MOTION CONTROL
3. TIME SET
4. PRIVACY ZONE
5. ALARM IN
6. ALARM OUT
7. SETUP
8. SYSTEM
9. SCHEDULE
10. STEP OUT INITIAL
This functions are set on OSD.
OSD Menu setup by the specialty controller
1) MENU : Press "MENU" button to go to the menu(P/T/Z function would be stopped.)
2) IRIS OPEN : Move to the sub menu or select the menu.
3) IRIS CLOSE : Move to the above menu or move the cursor to "EXIT"
4) JOY STICK :
ㆍRight : Move the cursor to the right or the sub menu.
ㆍLeft : Move the cursor to the left or the previous menu.
ㆍUp : Move the cursor to the above or increase the value.
ㆍDown : Move the cursor to the below or decrease the value.
*If you move the joystick when working this function(Pattern, Preset) the function will stop,
after finishing the control, the function will work again.
Chapter 4. Menu configuration and operating
Setting functions of speed dome such as Preset and Motion detection
Setting function of speed dome such as Sequence/Random Scan,
Custom/CW/CCW Scan and Pattern/Schedule
Set current time
Hide the points for which area masking is selected from the screen.
Set regarding sensor input
Set operation of the connected sensor
Set up for camera, motor and display
System setting such as Password, Reboot, Reset, System Information and
Step Out Init.
Schedule enables you to schedule a sequencing by day and time.
Compensate the pan position of camera
[Table 4-1] Main menu description
22