Advertisement
M
BSAP
OUNTING THE
BSAPs can be mounted in exterior applications or interior applications in harsh environments with an
operating temperature range of -40°F to 131°F (-40°C to 55°C). BSAPs should be positioned for
maximum throughput and range between other APs and wireless client devices. Follow these
instructions to mount the BSAP 2135 to a ceiling or wall:
1.
On a flat mounting surface, mark the locations of the four mounting holes using the plane bracket as
a template (Figure 1).
2.
Drill an 8 mm diameter hole with a depth of 36 to 38 mm into each of the markings (Figure 2).
3.
Hammer the expanding bolts into each of the drilled holes (Figure 3).
1
4.
Place the lock washers, then the flat washers on the four hex cap screws, and drive the screws
through the plane bracket into the back of the case (Figure 4).
5.
Install the antennas (sold separately) onto the appropriate antenna ports. The antenna ports are
labeled 2.4GHz and 5GHz.
6.
Insert the expansion bolts extending from the mounting surface through the holes in the plane
bracket, place the flat washers on the bolts, thread the nuts onto the bolts, and tighten to secure the
bracket to the mounting surface (Figure 5).
4
2
E
TO AN
XTERIOR
2
Plane Bracket
Mount Plane Bracket
to Unit
Expansion Bolt
Hex Cap Screw
C
W
EILING OR
Expansion Bolts
3
5
Support - Phone: 888-423-8726
ALL
Mount Unit on
Expansion Bolts
Advertisement
