Table of Contents
Advertisement
Off: Does not permit monitoring with a Web
browser.
Web Access
Select whether to permit access to the
Communication System via a Web browser.
Enabled: Permits access via a Web browser.
Disabled: Prohibits access via a Web
browser.
Telnet Access
Select whether to permit access to the
Communication System via Telnet.
Enabled: Permits access via Telnet.
Disabled: Prohibits access via Telnet.
SSH Access
Allows you to select whether to permit
access to the Communication System via
SSH (Secure Shell).
Enabled: Permits access via SSH.
Disabled: Prohibits access via SSH
Image Flip for Second Camera
Allows you to select whether to rotate the
camera image 180 degrees when the second
camera is installed on a ceiling.
Flip Vertical: Rotates the image 180
degrees.
Off: Does not rotate the image 180 degrees.
Note
The "Image Flip" function will be enabled after
system rebooting.
Administrator7
Other
Use History
Select whether to display the history lists in
order to use for dialing, etc.
On: Displays the history lists.
Off: Does not display the history lists.
Save Setup
Saves the data for each setting to a "Memory
Stick". The data for each setting saved on the
"Memory Stick" is overwritten.
Note
Phone Book and History data are not saved.
Load Setup
Loads the data for each setting from a
"Memory Stick". The data for each setting
saved on the System is overwritten.
Note
When saving and loading settings, make sure
that the version of the system from which the
data was originally saved is the same as the
version of the local system. If the versions
differ, the data may not be properly recognized.
AMX Device Discovery
Select whether to export AMX Device
Discovery information onto the network.
Off: Disables this function.
On: Enables this function.
When the AMX system is connected to the
Communication System via serial connection,
AMX Device Discovery information is output
via that serial connection.
AMX systems are external control devices
that can be used to control the
Communication System. When the AMX
system receives Device Discovery
information from the Communication
System, the System automatically falls
under the control of the AMX system.
HOP
Enter a number from 0 to 255 as the HOP
Display Terminal Name.
Auto Restore
Allows you to select whether to
automatically turn on the Communication
System if an power interruption occurs and
is then restored.
On: Enables the Auto Restore function.
Off: Disables the Auto Restore function.
Internet Protocol
IPv4: Uses the internet protocol version 4
(IPv4) that is commonly used.
IPv6: Uses the next-generation internet
protocol version 6 (IPv6).
IPv4/IPv6: Uses both IPv4 and IPv6.
Note
When "Internet Protocol" is set to "IPv6" or
"IPv4/IPv6", some of the functions of this
system are restricted, and some of the
Administrator setup menus are not displayed.
Registering Local Information
83
Advertisement
Table of Contents
