Table of Contents
Advertisement
• If battery leakage occurs, clean the battery compartment and replace all the
batteries with new ones.
Pairing the Remote Commander
The supplied Remote Commander controls the HD Visual Communication
System using the radio frequency of 2.4 GHz. The Remote Commander and
the Communication System are paired to prevent interference from other
Remote Commanders and Systems.
Pairing between the Remote Commander and the Communication System is
programmed at the factory.
Note
When performing the pairing procedure, be sure to turn off other HD Visual
Communication Systems located nearby that are not targets for pairing. If multiple
devices are turned on, the Remote Commander might pair device other than the target
one.
To pair the Communication System with the Remote Commander again
1
Turn on the Communication System.
2
Within three minutes after the power is on, locate the Remote Commander
closer to the Communication System, and press the RETURN and TOOLS
buttons at the same time.
The LED indicator flashes rapidly.
3
Press the ENTER button on the Remote Commander.
If the LED indicator flashes more slowly, pairing between the units has
succeeded.
34
Preparing the System
Advertisement
Table of Contents
