Sony Ipela PCS-G60 Operating Instructions Manual page 80

• Registering only the Administrator Password
will not enable password protection for
settings and Phone Book modification.
Always register the Phone Book
Modification Password and the Save Settings
Password in addition to the Administrator
Password.
• Be aware that registering other passwords
but leaving the Administrator Password
blank allows for modification and
connection from the Web page without
password input.
• Make sure to write down the Administrator
Password. If you should forget the
Administrator Password, consult your Sony
dealer. In this case, the memory of the
Communication System is initialized before
repair, and the data in the Phone Book and
History lists, as well as various setting data,
are erased.
Phone Book Modification Password
Use up to 8 alphanumeric characters and
symbols to register the password used for
Phone Book modifications.
Note
After you enter the Phone Book Modification
Password to modify Phone Books, unless you
switch to a different screen from the Phone
Book, modification will be enabled without
password reentry. In addition, modification
will be enabled without password reentry for
about 2 minutes after returning to the Home
menu from the Phone Book.
Save Settings Password
Use up to 8 alphanumeric characters and
symbols to register the password used for
saving settings.
Note
After you enter the Save Settings Password to
modify settings, unless you switch to a
different screen from the setup menu,
modification will be enabled without password
reentry. In addition, modification will be
enabled without password reentry for about 2
minutes after returning to the Home menu from
the setup menu.
80
Registering Local Information
Remote Access Password
Use up to 8 alphanumeric characters and
symbols to register the password used for
accessing the Web page.
Streaming Broadcast Password
Use up to 8 alphanumeric characters and
symbols to register the password used when
receiving and viewing video and audio
streams from PCS terminals on the Web
page.
Administrator2
Setup Password1
Allows you to select whether to require
"Save Settings Password" when saving each
setting.
Line Interface
Enabled: Requires "Save Settings
Password" when saving the Line
Interface settings.
Disabled: Does not require the password
when saving the Line Interface settings.
Dial
Enabled: Requires "Save Settings
Password" when saving the Dial setup
settings.
Disabled: Does not require the password
when saving the Dial setup settings.
Answer
Enabled: Requires "Save Settings
Password" when saving the Answer
setup settings.
Disabled: Does not require the password
when saving the Answer setup settings.
Multipoint (only with PCSA-MCG80
installed)
Enabled: Requires "Save Settings
Password" when saving the Multipoint
settings.
Disabled: Does not require the password
when saving the Multipoint settings.
IP Mode
Enabled: Requires "Save Settings
Password" when saving the IP Mode
settings.
Disabled: Does not require the password
when saving the IP Mode settings.