GRAPHTEC CS510 SERIES Service Manual page 99

(15) When the crosshairs cursor appears in the Scanner Adjustment window, click on the center of the top
center edge with the crosshairs cursor.
(16) Click the "Check" button, then click the "Set" button. The following dialog box will appear.
Click the "OK" button.
(17) Take out the CS600/500/IS200 adjustment test chart from the scanner. And then reinsert the
CS600/500/IS200 adjustment test chart to the scanner.
(18) Scan the offset target chart again.
Confirm that the starting point of the scanning is within the 7 pixels from the top of window as shown
below.
CS510/IS210-UM-251-9370
10. ADJUSTMENTS USING THE SOFTWARE
Click here with the crosshairs cursor.
Check the position by this indicator that the edge
is within the 7 pixels.
Position here with the mouse pointer,
and then check the position.
10-21