GRAPHTEC CS510 SERIES Service Manual page 55

Reattaching the drive rollers
(1) Reattach the drive rollers by reversing the sequence of steps in which they were detached.
(2) The front drive roller and the rear drive roller are different.
When installing a drive roller, check the mark on it to make sure that you have the correct one.
(3) Adjust the drive belt tension (see Section 8.9).
CS510/IS210-UM-251-9370
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
Install the drive roller with
this mark at the front.
Install the drive roller with
this mark at the rear.
8-7