GRAPHTEC CS510 SERIES Service Manual page 101

(7) Click in the center of the color tile indicated by the numbers 1 to 6, in ascending order.
For numbers 1 to 5, click the center of the upper left tile; for number 6, click in the center of the bottom
right tile. Align the cursor crosshairs with the printed lines at the sides of the tile.
• The next reference point to be checked is displayed on the Status bar.
• If you click in error, click the Esc. key to cancel the operation and return to the immediately previous step.
• If you click on the wrong tile, color correction will not be performed correctly and the colors of the image displayed
after color correction will be incorrect.
(8) After you have clicked tile number 6, click the Set button.
Click the OK button.
(9) To check the color correction results, click the Confirm button.
(10) The following message is displayed. Insert the color correction sheet in the scanner as instructed.
Position the color correction sheet so that the red bar in the center of the sheet is centered in the scanner (but with
the printed side down).
CS510/IS210-UM-251-9370
10. ADJUSTMENTS USING THE SOFTWARE
10-23