Install the expansion slot divider.
14.
Install the PCI-X Hot Plug expansion boards. If the server is powered off, use non-hot-plug procedures
15.
("Installing non-hot-plug expansion
is running, install PCI-X Hot Plug expansion boards using hot-plug procedures
expansion
Reinstall any expansion boards removed to install the PCI-X Hot Plug Mezzanine Option.
16.
Place the expansion slot covers over any remaining empty expansion slots, and close the latches.
17.
CAUTION:
all expansion slots have either an expansion slot cover or an expansion board installed.
Replace the access panel
18.
Slide the server back into the rack
19.
Power up the server (on page 24).
20.
Installing the PCI Express mezzanine options
Power down the server (on page 24).
1.
Extend or remove the server from the rack
2.
Remove the access panel
3.
Remove the expansion boards from slots 3 and 4, if installed, to gain access to the mezzanine
4.
connectors.
boards" on page 64).
To prevent improper cooling and thermal damage, do not operate the server unless
("Removing the access
("Extending the server from the
("Removing the access
boards" on page 63) to install the expansion boards. If the server
panel" on page 26).
("Extending the server from the
panel" on page 26).
("Installing hot-plug
rack" on page 24).
rack" on page 24).
Expansion board options 60