Testing The Operation Of The Outside Lever - Kaba E-PLEX 2000 Series Installation Instructions Manual

Hide thumbs Also See for E-PLEX 2000 Series:
Table of Contents

Advertisement

F-13 Remove the key. The lock will look as shown at right.
F-14 Gently check the rotation of the lever handle.
It should easily rotate approximately 45º.
Troubleshooting: If you have assembled the lever and
housing with the key in the wrong position, the key will get
stuck. To remove the key, turn it so that it is in the vertical
position and insert a small flat screwdriver into the hole
under the lever handle to push the lever catch in (f).
Remove key. If it is still stuck, turn the key clockwise until
it stops to the horizontal position and push the Lever
Catch in again with the small screwdriver. Remove key.
Troubleshooting: Right-Handed Lock: Turn the lever handle clockwise without
forcing it. If it stops at approximately 15º, it was not assembled correctly. Do
not try to force it to turn - this will damage the inside mechanism of the lock.
Release the lever handle. Insert the small screwdriver into the small hole on
the underside of the lever handle and push in the lever catch.
Re-do steps in section D
Left-Handed Lock: Turn the lever handle counter-clockwise without forcing. The
drive hub should not rotate when the lever handle is turned. If it does, it was not
assembled correctly. Release the lever handle. Insert the small screwdriver into
the small hole on the underside of the lever handle and push in the lever catch.
Re-do steps in section D
F-15 Using the 5/64" Allen Key, tighten the set screw while pushing the lever
against the plastic washer to remove the lever play.
G. TESTING THE OPERATION OF THE OUTSIDE LEVER
G-1 Verify that the lever has been correctly attached to the housing:
a. Remove key.
b. Insert a small flat screwdriver into the hole on the underside of the
lever handle and push in the lever catch.
c. Pull on the lever.
You should not be able to remove the lever. If the lever comes off of the
housing, the lock is not assembled correctly. Return to steps in section
D and repeat this verification process.
Right-Handed lock
Left-Handed
lock
39

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-plex 2400 series

Table of Contents