Kaba E-PLEX 2000 Series Installation Instructions Manual page 22

Place 3 spacers (S) on the door (for recent models only). Place the inside trim assem-
bly on the door so that the upper and lower spindles (F) and (G) engage the thumb-
turn and the inside lever. Fasten to the outside housing using the three 1/8" hex head
mounting screws (I).
Apply the privacy thumbturn sticker as shown. If in doubt as to the direction of the
arrow, press the auxiliary latch (X) to extend the deadbolt, and verify in which direc-
tion to rotate the thumbturn to reach the horizontal (privacy) position.
RH/LHR LH/RHR
Turn Knob Vertical
X
Note: For Auto Deadbolt models the gap between the mortise front plate and the
strike must not exceed 1/4 "
Door Door Frame
Mortise
Max. 1 / "
4
22