Kaba E-PLEX 2000 Series Installation Instructions Manual page 30

8. Three AA batteries should already be installed in the battery holder (C).
Insert the battery holder into the outside housing and secure it using the
supplied 6-32 x 5/16" (7.9mm) Phillips screw (H).
Note: If the lock makes a continuous buzzing noise or the red LED lights
continuously, reset the electronics by removing the battery holder for ten
seconds then reinsert it.
B-6. Reversing the Outside Lever
(for Series without Mechanical Override)
The lever is field reversible. If the handing is incorrect, insert a small pick or
flat screwdriver in the hole in the hub as shown. Gently pry back the spring clip
inside the hub, and remove the handle.
Access Hole
cut-away view
28
C