Freefly M?VI Controller User Manual page 27

SYMPTOM
Bind Failed. Receiver Status LED:
(Slow-Flashing Red) OR
(Solid Red)
A user input (e.g. Pan Speed Knob, Mode Switch)
is not working.
The Pan/Tilt Axes are not working
P27
POSSIBLE CAUSE
MōVI Controller was not detected.
MōVI Controller did not allow binding.
The input has been remapped in Tx Config.
The input is broken/damaged.
Pan/Tilt Speeds are at their minimum settings.
The MōVI is in Majestic Mode.
SOLUTION
Make sure the MōVI Controller is powered on and
in range. Turn off any other MōVI Controller that
might be in range.
Use Radio Config::Radio Action::Bind
binding after the Receiver Status LED changes to
slow-flashing orange:
(See binding instructions in the Receiver section.)
Check the assignment of USER 1, USER 2, and
USER 3 in the Tx Config menu to see if the user
input in question has been remapped to one of
these.
Many user inputs can be remapped. For example,
the Mode Switch can be remapped to the USER 3
switch. See the Tx Config menu section for more
information.
Increase these setting using the Speed Knobs.
Change to Dual Op. mode using the Mode Switch.
to permit