Insert With Positive Connection; Insert With Direct Connection (Masonry Fireplace) - Travis Industries Flush Wood Plus Owner's Manual

14 Fireplace Insert Installation
Insert with
Positive
Connection
REQUIRED IN
CANADA.
Insert with Direct
Connection
(Masonry
Fireplace)
NOT ALLOWED IN
CANADA.
A block-off plate or
other non-combustible
sealing device (e.g.
damper adapter) is
required. It must seal
the chimney to insure
smoke does not enter
the home while
providing the chimney
system with sufficient
draft.
© Travis Industries
Install a non-combustible
cover plate to prevent water
from entering the chimney
Combustible Mantle
See the section "Insert
Placement Requirements" for
minimum clearances and
hearth required.
Stainless steel chimney
connector must Extend 1'
past the block-off plate or to
the flue liner
Combustible Mantle
Surround Panels
See the section
"Insert Placement
Requirements" for
minimum clearances
and hearth required.
(for qualified installers only)
100-01259
Cap (prevents water from
entering)
Flue Liner
The liner must be stainless
steel connector or flexible vent.
Follow the liner manufacturer's
instructions for installation and
support.
Airtight Insulated
Clean-Out
Remove damper or wire it open
We recommend using non-combustible
fiberglass insulation to seal the fireplace
enclosure (chimney top and bottom, and
surround panels)
Seal the flue connection to the insert
Flue
Liner
Airtight
Insulated
Clean-Out
Remove
damper
or wire it
open
Block-off plate or
damper adapter
4150520
Figure 6
Figure 7