Insert With Positive Connection; Insert With Direct Connection (Masonry Fireplace) - Travis Industries Flush Wood Plus Owner's Manual

16 Fireplace Insert Installation
Insert with
Positive
Connection
REQUIRED IN
CANADA.
Insert with Direct
Connection
(Masonry
Fireplace)
NOT ALLOWED IN
CANADA.
A block-off plate or
other non-combustible
sealing device (e.g.
damper adapter) is
required. It must seal
the chimney to insure
smoke does not enter
the home while
providing the chimney
system with sufficient
draft.
© Travis Industries
Install a non-combustible
cover plate to prevent water
from entering the chimney
Combustible Mantle
Surround Panels
See the section "Insert
Placement Requirements" for
minimum clearances and
hearth required.
Stainless steel chimney
connector must Extend 1'
past the block-off plate or to
the flue liner
Combustible Mantle
Surround Panels
See the section
"Insert Placement
Requirements" for
minimum clearances
and hearth required.
(for qualified installers only)
100-01269
Cap (prevents water
from entering)
Flue Liner
The liner must be
stainless steel
connector or flexible
vent. Follow the liner
manufacturer's
insturctions for
installation and
support.
Airtight Insulated
Clean-Out
Remove damper
or wire it open
Figure 9
Flue
Liner
Airtight
Insulated
Clean-Out
Remove
damper
or wire it
open
Block-off plate or
damper adapter
Figure 10
4110712