Table of Contents
Advertisement
Quick Links
864 HH Fireplace
• Operation
• Maintenance
WARNING: If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or loss of life.
-
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or
any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire department.
-
Installation and service must be performed by a qualified installer, service agency or the
gas supplier.
This appliance may be installed in an aftermarket permanently located, manufactured home (USA only)
or mobile home, where not prohibited by local codes.
This appliance is only for use with the type(s) of gas indicated on the rating plate. A conversion kit is
supplied with the appliance.
Owner's Manual
Copyright 2008, T.I.
$10.00
100-01181_003
Tested and Listed by
OMNI-Test Laboratories, Inc.
Beaverton, Oregon
Report # 028-F-59b-5
ANSI Z21.88b-2003
4080218
4800 Harbour Pointe Blvd. SW
Mukilteo, WA 98275
Advertisement
Table of Contents
Related Manuals for Travis Industries 864 HH
Summary of Contents for Travis Industries 864 HH
- Page 1 864 HH Fireplace Tested and Listed by • Operation • Maintenance OMNI-Test Laboratories, Inc. Beaverton, Oregon Report # 028-F-59b-5 ANSI Z21.88b-2003 WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
-
Page 2: Introduction
Please familiarize yourself with the Owner's Manual before operating your heater and save the manual for future reference. Important Information No other 864 HH gas fireplace has the same serial Register your warranty online at: number as yours. The serial number is on the listing label that is chained to the gas control valve. -
Page 3: Table Of Contents
Heating Specifications Natural Gas Propane Approximate Heating Capacity (in square feet)* 1,200 to 2,250 1,200 to 2,250 Maximum BTU Input Per Hour 40,000 39,000 Heating capacity will vary with floor plan, insulation, and outside temperature. © Travis Industries 100-01181_003 4080218... -
Page 4: Safety Precautions
Immediately call a qualified vicinity of this heater. service technician to inspect the appliance and to replace any part of the control system and any gas control that has been under water. © Travis Industries 100-01181_003 4080218... - Page 5 If the fiber logs become damaged, replace with Travis Industries log set. Children and adults should be Travis Industries, Inc. grants alerted to the hazards of high no warranty, implied or stated, surface temperature and for the installation or...
-
Page 6: Operation
Blower Control This knob controls the speed of the internal convection blower that pushes heated air into the room. Optional Accent Light This knob controls the optional accent lights located behind the logs. © Travis Industries 100-01181_003 4080218... - Page 7 With the pilot lit, proceed to step “f”. Replace the glass. Turn the gas control knob counter- clockwise to "ON". The pilot is now lit and the heater can be turned on and off. © Travis Industries 100-01181_003 4080218...
-
Page 8: Starting The Fireplace For The First Time
Your fireplace has an adjustable flame to tailor the look and heat output to your specific needs. It is adjusted by turning the middle dial on the gas control valve. Index Mark Flame Height Adjustment Knob Turn counter-clockwise to adjust the flame higher, clockwise to lower. © Travis Industries 100-01181_003 4080218... -
Page 9: Adjusting The Blower Speed
This appliance has several areas that reach high temperatures. Dust or other particles on these areas may burn and create an odor. This is normal during start-up. You may notice the smell is more acute if the appliance was left idle for a long period. © Travis Industries 100-01181_003 4080218... -
Page 10: Maintenance
If the pilot or main burners do not burn correctly, contact your dealer for service. Monitor the blower operation. Remove any debris or vegetation near the vent termination. Contact your dealer if any sooting or deterioration is found near the vent termination. © Travis Industries 100-01181_003 4080218... -
Page 11: Grill Installation And Removal
(this prevents the it allows the grill to swing bushing. Once in place the grill is grill from accidentally falling off). forward. held in place by gravity. © Travis Industries 100-01181_003 4080218... -
Page 12: Face Installation And Removal
Some fireplaces have a face that fits over the glass frame. The face can be removed following the directions below. Phillips Screwdriver Four screws hold the face in place. The screws are accessed through the grills on the face. © Travis Industries 100-01181_003 4080218... -
Page 13: Glass Frame Removal And Installation
Lift the glass frame slightly and attach the lower latches. NOTE: Make sure the glass frame is all the way in place - it should be flush with the front of the fireplace when installed. © Travis Industries 100-01181_003 4080218... - Page 14 Top of Firebox Glass Frame Anchor Note how the washer on the latch fits behind the flange on the glass frame anchor. Once fully inserted, turn the latch until it is upright. © Travis Industries 100-01181_003 4080218...
-
Page 15: Log Set Installation
Note how the notch on the right log hangs over the side of the burner. Rotate the inward tip of the log forward so it is directly next to the burner holes. © Travis Industries 100-01181_003 4080218... - Page 16 Left Log Installation This hole and pin are Place the left log so this pin not utilized. inserts into the hole on the bottom of the log. When in place, the logs should look like this. © Travis Industries 100-01181_003 4080218...
- Page 17 VERIFY REAR LOG POSITION With all the logs in place, verify the rear log is vertical and all the way back – this will insure proper air flow and prevent sooting. © Travis Industries 100-01181_003 4080218...
- Page 18 A bag of embers is provided to further enhance the firebox. Place the embers on the firebox floor and on the burner (especially over exposed screws on the burner). Do not place embers over any of the burner holes or air channels. © Travis Industries 100-01181_003 4080218...
-
Page 19: Glass Cleaning
Maintenance Glass Cleaning The glass may be cleaned with a non-abrasive cleaner. To clean the inside of the glass, simply remove the glass frame, place it on a non-scratching surface, and clean the inside surface. © Travis Industries 100-01181_003 4080218... -
Page 20: Troubleshooting Table
See "Adjusting the Flame Height" Short (Under 6") The logs or coals are placed incorrectly See "Log Set Installation" Thin Layer of Soot Improper air shutter adjustment Adjust Air Shutter - contact your dealer Covers the Glass © Travis Industries 100-01181_003 4080218... -
Page 21: How This Fireplace Works
This valve is placed on the gas line amount of electricity. If the pilot flame to shut off gas to the appliance goes out, the gas valve automatically during maintenance procedures. shuts off all gas. © Travis Industries 100-01181_003 4080218... -
Page 22: Wiring Diagram
Optional Snap Disk Black Blue Optional Regulator Solenoid (24 V. DC) Blue Gas Control Brown Valve (millivolt DC) Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. © Travis Industries 100-01181_003 4080218... -
Page 23: Replacement Parts List
Maintenance Replacement Parts List Caution: Use only Travis Industries replacement parts. Do not use substitute materials. Warning: Do not operate appliance with the glass front removed, cracked, or broken. Replacement of the glass should be done by a licensed or qualified service person. -
Page 24: Warranty Warranty
At that time, you may be asked to ship your appliance, freight charges prepaid, to TRAVIS INDUSTRIES, INC. TRAVIS INDUSTRIES, INC., at its option, will repair or replace, free of charge, your TRAVIS appliance if it is found to be defective in material or workmanship within the time frame stated within this 7 year warranty. -
Page 25: Optional Equipment
This accessory allows for remote control of your fireplace. Extra Room Power Heat Duct Installed behind the wall, the extra room power heat duct pulls heat from the fireplace and blows it into a separate location. © Travis Industries 100-01181_003 4080218... -
Page 26: Index
Warranty ............24 Important Information..........2 Window Cleaning..........19 Installation Warnings...........2 Window Removal and Installation ......13 Introduction ............2 Wiring Diagram..........22 Location of Controls..........6 Yearly Service Procedure........10 Log Set Installation ..........15 Maintaining Your Fireplace's Appearance ....10 © Travis Industries 100-01181_003 4080218...