Download Print this page

Front Panel; Rear Panel - Extron electronics DTP T HWP 232D Setup Manual

Twisted pair wallplate extenders

Advertisement

DTP T HWP/UWP 232/332 D • Setup Guide (Continued)
Step 3 — Connect Inputs to the Transmitter

Front Panel

AUDIO IN
A
HDMI IN
B
IR OUT
D
G
S
Extron
A
Audio input connector — Connect an unbalanced stereo audio source to this 3.5 mm mini stereo jack.
B
HDMI input connector — Connect an HDMI cable between this port and the output port of the digital video source.
C
VGA input connector — Connect a VGA cable between this port and the output port of the video source.
D
IR output connector — Connect an IR device to this 2-pole, 3.5 mm captive screw
pass-through connector for IR control. Wire the cable as shown in the illustration to the right.
E
Mini USB port — Connect a male Mini USB-B cable to this port for SIS configuration and
firmware updates.

Rear Panel

A
DC power input connector — Wire and plug the included external
12 VDC power supply into either this 2-pole connector or the power
input connector on the receiver (see the DTP T HWP/UWP 232/332 D
User Guide at
www.extron.com
B
Over DTP connector — Connect an RS-232 device to this 3-pole,
3.5 mm captive screw connector for pass-through RS-232 control.
C
Remote connector — Connect an RS-232 device, contact closure
device, or both to this 5-pole, 3.5 mm captive screw connector to
control switching on the unit. Wire the connector as shown in the
diagram below.
RS-232 — To control the unit through this port, connect an RS-232
device and configure it as follows: 9600 baud rate, 8 data bits,
1 stop bit, no parity.
Contact — Momentarily short pins 1 or 2 to ground (G) to select
the corresponding input. Connect pins 1 and 2 to ground (G) to
set the unit to auto switch mode. The device selects the highest
active input (auto switch).
Tx/Rx
Pins
2
AUTO SW
AUDIO IN
HDCP
1
HDMI IN
2
CONFIG
DTP T HWP 232 D
for wiring information).
Connected RS-232 and
Contact Closure Device Pins
Pin 2 for contact closure control
Pin 1 for contact closure control
Ground
Transmit pin on connected unit
Receive pin on connected unit
AUDIO IN
A
A
HDMI IN
B
B
IR OUT
D
E
G
S
Extron
E
AUTO SW
AUDIO IN
HDCP
1
VGA IN
CONFIG
DTP T UWP 232 D
G
S
R
DTP T HWP 232 D and DTP T UWP 232 D
Rear Panel
A
DC power input connector
B
Over DTP connector
C
Remote connector
D
DTP OUT connector
E
Reset button
(page 3)
A
C
E
Ground
Signal
3/16"
(5 mm) Max.
A
B
E
C
D
(page 3)

Advertisement

loading
Need help?

Need help?

Do you have a question about the DTP T HWP 232D and is the answer not in the manual?

This manual is also suitable for:

Dtp t hwp 332d