18. Install the Cooling Solution Assembly on the Motherboard.
a. Position the assembly over the CPU and tighten the six spring‐loaded screws.
Note: Use a sequential rotating pattern when loosening the spring‐loaded
screws. Tighten each screw a little at a time to evenly raise the Heatsink from
the CPU.
b. Secure the assembly to the chassis (2 screws).
Note: After powering up the terminal, re‐flash the BIOS to ensure the latest version
is installed and verify that the terminal is fully functional (see the BIOS Updating
Procedures chapter in the NCR RealPOS 60 User Guide (B005 0000 2011).
Hardware Disassembly
28751a
Screws
28749a
17