Storage/Ide Drives Test - NCR RealPOS 60 Hardware Service Manual

Storage/IDE Drives Test

1. Select Storage/IDE Drives
Storage/IDE/SATA Device Information
1) Primary Master:[NOT DETECTED]
2) Primary Slave:[NOT DETECTED]
3) Primary Master:[NOT DETECTED]
4) Primary Slave:[NOT DETECTED]
5) SATA 1:[SATA Hard Disk]
6)SATA 2:[NOT DETECTED]
7)SATA 3:[NOT DETECTED]
8)SATA 4:[NOT DETECTED]
0) Exit Storage/IDE Device Information
Select:
2. Select from the list to perform the desired test(s).
Testing SATA Hard Drive
Connection : SATA1 (via /dev/sdb)
Model/MFG : ST380215AS
Capacity : 80.0 GB
Operating Mode: RAID/AHCI
Information current as of [today's date/time]
1 Display SMART overall-health assessment
2 Display SMART disk error log
3 Display SMART disk selftest log
4 Perform SMART "short" non-destructive selftest (1 - 5 minutes)
5 Perform SMART "long" non-destructive selftest (up to 1 hour)
6 Abort SMART selftest (short or long)
0) Exit IDE Hard Drive Test
Select:
(3) and press [Enter]. Select the device you want to test.
Diagnostics 7