Barco NGS-D200 User Manual page 52

N
OTE: When you have finished making changes, click "Apply" at the bottom of the page. Click "Save Settings" to
permanently save your changes to the device.
11.2.3 Auto Detect Video Timings From DVI
N
OTE: This option is used when DVI input is used.
Enable AutoLUT: check to enable
l
It makes the operation in DVI mode easier. User does not need to create look up tables (LUTs) manually for input video
timing detection. NGS-D200 can automatically create a video LUT from input video timings.
When this option is enabled, other LUTs created in the system are ignored for video detection and the auto created
LUT takes precedence.
If Use Preferred Video Timings from Monitor option is disabled, LUTs in the sytem can be used to announce specific
video timings over EDID to source connected at input (not a common case)
N
OTE: When you have finished making changes, click "Apply" at the bottom of the page. Click "Save Settings" to
permanently save your changes to the device.
11.2.4 Encoder Video Parameters
Once a connection is made, you can dynamically optimize the video quality by adjusting the video parameters.
Table 11-1: Default/Valid Encoder Video Parameters
Field
Sampling Phase
Local Video Output
Fine Noise Elim
Course Noise Film
Horiz Position
Vert Position
LUT Change Pump Curr
Optimize Latency
I-Frame Interval
Sampling Phase: (Analog Video Only) The sampling phase is adjusted to minimize noise of the video source that is
l
result of the source's hardware (video card, cables, etc.) and video resolution. Ideally, this field should be set to a
level that minimizes bandwidth usage. You can check the bandwidth usage from the Display Connection
Information Page to find a sampling phase that works best for your deployment
K5903085
Default Value
0
Yes
16
10
0
0
Auto
No
0
Valid Entries
-16-15
Yes, No
1-2048
1-256
-135-375 (px)
-25-50 (px)
Auto, 50, 100, 150, 250, 350,
500, 750, 1500 (µA)
Yes, No
1-256 (ms)
Chapter 11: Video
44