Barco NGS-D200 User Manual page 41

Chapter 8: Streaming
You must specify the connection to use audio via the Connection Manager Table page.
l
8.2.7.2 Enabling Reverse Audio
Enable: check to enable reverse audio
l
N
OTE: When you have finished making changes, click "Apply" at the bottom of the page. Click "Save Settings" to
permanently save your changes to the device.
N
OTE: You can choose which audio input (Mic in
information, see "Audio Mixer Configuration" on page 51
8.2.8 Audio/Video Ports Range
You can adjust the audio/video port ranges of the device if needed.
N
OTE: The default A/V port range is 6060 - 6399.
For Standalone encoders: designate any open ports 6060 – 7000 (default range)
l
For Standalone decoders: designate any port range outside of the default range
l
N
OTE: When you have finished making changes, click "Apply" at the bottom of the page. Click "Save Settings" to
permanently save your changes to the device.
8.2.9 Authorization Table
The Authorization Table provides protection against unwanted access to your encoder. You can authorize clients from
specific IP addresses or networks to connect to be able to connect to the encoder.
N
OTE: You must select "Use Authorization Table" under the Connection Profile section of the page in order to
expose the Authorization Table section of the page.
N
OTE: The Authorization Table only applies for Standalone Mode connections. For more information, see
"Standalone Mode" on page 58
Certain priorities apply when overlapping Authorization Tables entries are configured:
For example, assume there are two entries in the list:
1. IP Address: 10.1.0.0, Netmask: 255.255.0.0, Bandwith: 10M
2. IP Address: 10.1.5.50, Netmask: 255.255.255.255, Bandwidth: 10 M
The more specific entry (Entry #2) will be solely enforced.
Suppose a third entry is added to the list. Two entries are equally 'specific':
1. IP Address: 10.1.0.0, Netmask: 255.255.0.0, Bandwidth: 10M
2. IP Address: 10.1.5.50, Netmask: 255.255.255.255, Bandwidth: 10 M
3. IP Address: 10.1.5.50, Netmask: 255.255.255.255, Bandwidth: 20 M
Entry #2 will be solely enforced because it is higher in the list than Entry #3
33
or Line In ) will be used for reverse audio. For more
NGS-D200 User Guide