Secure SRT321 User And Installation Instructions Manual page 18

Association
Command Class
Configuration
Command Class
Note: All command classes are version 1 unless otherwise stated.
The following association groups are supported:
Group 1 - Nodes controlled by Thermostat Mode
SET command.
Group 2 - Nodes controlled by Binary Switch
SET command.
Group 3 - Nodes to receive unsolicited Battery
Level Reports or Low Battery Warnings.
Group 4 - Nodes to receive Thermostat Set Point
Reports.
Group 5 - Nodes to receive unsolicited Multilevel
Sensor Reports.
Each group contains a maximum of 4 nodes
The unit supports 3 single byte configurations for
the temperature sensor in the range 1-3
respectively.
Configuration Parameter Number 1, Default = 0
0x00 - 0x7F Disables the temperature sensor.
0x80 - 0xFF Enables temperature sensor.
Configuration Parameter Number 2, Default = 0
0x00 - 0x7F Celsius.
0x80 - 0xFF Fahrenheit.
Configuration Parameter Number 3, Default =
10 (1.0˚C)
1 to 100 - Delta Temperature in 0.1˚C steps
18