Table of Contents
Advertisement
Audio Configuration
To configure audio settings of the OPS200, plug all audio inputs into
the device, and click on the Audio tab of the RCS home page.
1/ Set the Main audio output level and delay (accessible only if Delay
Mode is set to Manual Adjust, see also the "Audio Configuration"
chapter), or click the Mute button to mute Main audio output.
2/ Repeat step 2 for the Prelist audio output.
3/ Individual source settings (level and balance) for each audio input
can be configured in the right hand section of the Audio tab.
49
Advertisement
Table of Contents
Need help?
Do you have a question about the Ops200 and is the answer not in the manual?