Working With Frames; Memorizing Frames; Working With Logos - Analog way Ops200 User Manual

Working with Frames

It is possible to store up to 7 frames in the
memory. Frames are mainly used as backgrounds in a typical
show or event setup, and can be recorded from any of the
11 sources and called back at the press of a single button.
* NOTE * : Frames may be used only one at a time and cannot be
placed in a layer.

Memorizing Frames

1/ In the Input Selection section, press the source button (#1 to #11)
of the source you wish to record as a frame. The source button
will start blinking. Press the
on the main display.
2/ Select Logos/Frames in the menu by rotating the scroll knob, then
pressing the [ENTER]
3/ Select Record Frames in the Logo/Frames menu by rotating the
scroll knob, then pressing the
will appear on your main display, indicating the frame which will
be captured. Select an empty frame memory (empty frames
are indicated in the sub-menu) to store the frame into. Press the
corresponding [ENTER]
4/ The OPS200 will display a progress status bar on the VFD
screen. Your frame is stored when the menu reappears on the
VFD screen.
5/ Press the [BACKGROUND FRAME]
number (#1 to #7) you just recorded, and press the
Your background frame will appear on your preview output.

Working with logos

It is possible to store up to 7 logos in the
memory. Logos work in much the same way as frames, and can be
recorded from any of the
more attributes than frames. They can be sized, positionned, but
also keyed via color cutout selection or luma key.
30
OPS200
[TAKE] button to display that source
button.
[ENTER] button. A white rectangle
button.
button, select the frame
OPS200
OPS200 11 sources. Logos have many
non volatile
OPS200
[TAKE] button.
non volatile
+